Eagle Tips

来自Jack's Lab
2021年1月19日 (二) 14:41Comcat (讨论 | 贡献)的版本

跳转到: 导航, 搜索

目录

1 Notes

  • 力创的喷锡 PCB,2.54mm 的插针,钻孔必须为 0.9mm,0.7mm 的只能用在镀金板上!2.54mm间距的母座可用0.7mm的喷锡孔
  • 力创的丝印,最小最好为 24mil, Ratio 14%


  • Eagle Lib: 封装的 name 和 value 建议字符格式:vector, 16mil 8% / 50mil, 8%


  • 力创开卡槽,可能用的 0.5mm 的铣刀,因此如果是 5mm x 1mm 的槽,最好开成 5.5 - 6 mm x 1mm


FR-4 板材参数:

  • 介电常数 (Dielectric Constant): 4.58
  • 介质损耗 (Loss Tangent): 0.022
  • 1oz 铜,厚 0.035mm (35um)


http://www.kblaminates.com/chs/upfile/2010123017220691104.pdf

2 Change Fonts

Two steps: First smash all the parts to make sure you can access the part names, then change the font and ratio.

To smash all the parts, try:

    display none tOrigin bOrigin;
    group all;
    smash (>0 0);
    display last;

To change the font and ratio, try:

    display none tNames bNames;
    group all;
    change font vector (>0 0);
    change ratio 15 (>0 0);
    display last;



3 Export wiki

Run the DP_Exporter.ulp to create Board and Schematic PNG, a HTML table and WIKI table format:

  • Load a board (You must be in the board screen, not in schematic to run the script)
  • From File->Run load up DP_Exporter.ulp



4 Export BOM from brd

Run the 204BRD2XLS.ULP to create the BOM list of the *.brd file



5 Export Silkscreen to PDF

Open *.brd file

5.1 Top

display none tNames Dimension
print


5.2 Bottom

display none bNames Dimension
print



6 Export mnt

run mountsmt.ulp



7 过孔和线宽与电流关系

铜厚 1oz,线宽单位 mil

上升10摄氏度

  • 6mil 0.2A
  • 8mil 0.55A
  • 12mil 0.8A
  • 16mil 1.1A

设计时需要小于该值的一半考虑。

过孔的对应的导线宽度为焊盘边缘宽度,即10mil的孔,16mil的焊盘外径则对应6mil的导线。

RT5350F全开时电流为280mA,约为3.3V * 0.28A = 0.924W

其中天线发射功率为100mW,大概40mA的电流,用6mil的导线就够了。

接地过孔必须可以承受约0.5A的电流,所以16mil的过孔至少要6个,越多越好



个人工具
名字空间

变换
操作
导航
工具箱