Noduino SHT2x
来自Jack's Lab
(版本间的差异)
(以“== 开发环境准备 == 根据您的系统,选择如下快速指南: * Getting Started with Noduino SDK on Linux * [[Getting Started with Noduino SDK on ...”为内容创建页面) |
(→查看) |
||
第46行: | 第46行: | ||
<br><br> | <br><br> | ||
− | == | + | == 查看结果 == |
上传完之后,用串口工具,用 115200 的波特率打开串口,即可看到串口在持续输出传感器测得的温度湿度值: | 上传完之后,用串口工具,用 115200 的波特率打开串口,即可看到串口在持续输出传感器测得的温度湿度值: | ||
第87行: | 第87行: | ||
+ | <br><br> | ||
+ | |||
+ | == 代码示例 == | ||
+ | |||
+ | <source lang=cpp> | ||
+ | |||
+ | </source》 | ||
2016年8月28日 (日) 09:14的版本
目录 |
1 开发环境准备
根据您的系统,选择如下快速指南:
- Getting Started with Noduino SDK on Linux
- Getting Started with Noduino SDK on Mac OS X
- Getting Started with Noduino SDK on Windows
2 硬件准备
3 编译烧写
进入你的 sht2x 目录:
$ cd /PATH/TO/noduino-sdk/examples/noduino/sht2x/
编译、上传一步完成:
$ make flash
不同平台下,你的串口设备号可能不一样,确认一下你的串口设备,Linux 下 Falcon 开发板可能被识别为 /dev/ttyUSB1(dmesg 查看),则:
$ make flash ESPPORT=/dev/ttyUSB1
Windows 下 Falcon 开发板可能被识别为 COM6(控制面板 --> 设备管理器里查看),则:
$ make flash ESPPORT=COM6
4 查看结果
上传完之后,用串口工具,用 115200 的波特率打开串口,即可看到串口在持续输出传感器测得的温度湿度值:
Windows 下可用串口调试助手这类插看
Linux 下推荐使用 picocom:
$ sudo apt-get install picocom $ picocom -b 115200 /dev/ttyUSB1 picocom v1.7 port is : /dev/ttyUSB2 flowcontrol : none baudrate is : 115200 parity is : none databits are : 8 escape is : C-a local echo is : no noinit is : no noreset is : no nolock is : no send_cmd is : sz -vv receive_cmd is : rz -vv imap is : omap is : emap is : crcrlf,delbs, Terminal ready ...... ......
Ctrl + a q 退出 picocom
5 代码示例
</source》 <br><br> == 扩展阅读 == ;;更多问题参考: * [[Noduino]] <br><br> <br><br> <br><br>