Noduino Quantum
来自Jack's Lab
目录 |
1 Overview
- CP2102 USB to UART Chip
- ESP32 Bluetooth and WiFi SoC
- 40MHz Crystal (±10ppm, ±10ppm)
- 16MB SPI Flash (25Q128xxx, QIO, 80MHz)
- 5V - 12V Power Supply
- UART Baud rate is 115200
2 Pin Map
We place the PIN map on the back of the board:
You guys can refer to this doc for more information: http://www.espressif.com/sites/default/files/documentation/esp32_chip_pin_list_en_0.pdf
3 Quick Start
3.1 USB2UART
Quantum use the CP2102 USB to UART chip, you need to install the driver firstly. Accessing following url to get your driver:
The default baud rate is 115200
3.2 Linux
Please refer to: https://github.com/icamgo/esp-idf/blob/master/docs/linux-setup.rst
3.3 MAC OS
Please refer to: https://github.com/icamgo/esp-idf/blob/master/docs/macos-setup.rst
3.4 Windows
Please refer to: https://github.com/icamgo/esp-idf/blob/master/docs/windows-setup.rst
4 Turtorial
- ESP32 Smartconfig WeChat Airkiss by default
- ESP32 JTAG
5 Peripherals
- ESP32 TSL2561 TSL2561 Digital Luminosity/Lux/Light Sensor
- ESP32 BH1750 BH1750 Digital Light Sensor
- ESP32 BMP180
- ESP32 BMP085 BMP085 Barometric Pressure/Temperature/Altitude Sensor
- ESP32 SHT2x SHT2X Digital Humidity & Temperature Sensor
- ESP32 DHT21 DHT21(AM2301) Digital Temperature & Humidity Sensor
- ESP32 DHT11 DHT11 Digital Humidity & Temperature Sensor
- ESP32 PT1000 Using a 18-bit ADC MCP3421
- ESP32 Partical Sharp GP2Y1010AU0F Particle Sensor support
- ESP32 PCF8563 PCF8563 I2C RTC Chip
- ESP32 SSD1306 OLED Screen
6 ESP32 Arch
ESP32 block diagram:
- Xtensa Instruction Set Architecture: http://0x04.net/~mwk/doc/xtensa.pdf
- Xtensa LX6 Core: http://ip.cadence.com/uploads/533/Cadence_Tensillica_Xtensa_LX6_ds-pdf
7 Hardware
8 Reference
- For more information please refer to